Almighty Lord: I can modify hidden entries.

Chapter 107 Mechanical recording, mass production of magic weapons!
Gooden left immediately after getting the information he wanted, not daring to stay in Helisa's room for a second longer, he couldn't bear this kind of blessing now.

Seeing Gudeen leaving in a hurry, Helisha, who was lying on the soft chair, couldn't help chuckling.

"It's really a little different..."

……

After leaving Helisa's room, Gudeen immediately went to his small vault and took some coins to try.

The three metals were smelted by fire and quickly turned into ingots. Looking at the small gold bars in his hands, Gudeen couldn't help but fell into deep thought.

Just such a small gold bar of less than 30 grams can smelt more than [-] gold coins from him. If this thing is to be used as a magic weapon recording material, the price will skyrocket.

However, compared to authentic magic metals, the price of gold is considered the cheapest of the cheap.

In addition, when building, it does not need to be made of a single metal. It is only necessary to burn the magic array on the core part and use these metals that are resistant to elemental erosion.

With the idea and preparation of materials, Gudeen left and began to use manganese steel as the material to try to burn the magic circle for experimentation.

For the second-generation magic rifle, Gooden's design idea is to place the overlapping magic nodes on the 'hammer' at the end of the gun.

Under normal circumstances, the hammering is released, and when the trigger is pulled, the tiny mechanical arm is used to pull the impact and coincide, allowing the elements of the entire magic circle to circulate and trigger an implosion thrust.

Of course, in order to avoid the explosion of the magic circle, Gudeen set the amount of elemental magic absorbed by the word at the level that can just release a fireball.

In this way, even if the element node on the hammer is disconnected, there will be no overflow of elemental magic power.

At the same time, taking into account the metal embrittlement effect caused by the erosion of magic power, Gooden made the structure of the magic power burner a detachable modular treatment.

Such a simple change counted burning the magic circle, and Gudeen didn't even use it for half an hour.

With such a rapid development work, he couldn't help but marvel at the convenience of magic again.

After the completion of the production, the next step is to test, pull the trigger, complete the magic construction, and trigger the implosion of the fireball.

"boom……"

A slight explosion sound came from the cavity, and this sound also represented that there was no problem with his train of thought.

Then Gudeen pulled the trigger continuously to check the upper limit of the second-generation magic rifle's rate of fire and how long it could withstand the erosion of elemental magic power.

This test didn't load it with bullets, it was just purely pulling the trigger to continuously release magic.

As the trigger was pulled continuously, in the end more than three hundred times, the manganese steel carrier that burned the magic array could not withstand the erosion of the elemental magic power, and burst into pieces with a click.

Fortunately, Gooden, who was prepared in advance, arranged defensive measures, so that the broken metal fragments were not hurt.

The pure manganese steel carrier can be shot more than [-] times before it breaks. This kind of performance performance is also a little surprising to Gu Deen.

Originally, he thought that ordinary metals would be able to resist a hundred times at most, but he didn't expect it to be three times higher than he expected.

It seems that manganese steel may be used as a consumable to make an alternative material...

After recording the experimental data, Gu Deen quickly built a "gun receiver" with copper as the carrier. After the first experience, he was obviously more proficient in the second time.

The production was completed in less than 10 minutes. After replacing the broken manganese steel 'magic gun receiver', Gooden pulled the trigger frantically again.

This time, the result of using copper as the carrier also surprised Gudn a little, and it took more than [-] shots before it broke.

Then the test results of the two metals of silver and gold were [-] and [-] respectively.

According to the most economical point of view, it seems to be the most appropriate to use silver metal as the core recording material of the second-generation rifle.

Although the number of [-] times is a bit small, it is not unacceptable considering the ease of maintenance of this weapon.

After all, it's just changing the receiver of the gun. This kind of simple mechanical replacement work, this kind of small skill will definitely let the soldiers below learn in a unified way later, don't worry about them not being able to master it.

After completing the recording work, Gudeen washed up and went to rest, and the rest of the work will come back tomorrow.

……

It was already after noon when Gudeen took over the development of weapons again the next day.

The affairs piled up yesterday didn't work all day long, and after a morning's confirmation and verification, Gudeen had time now.

But it was also this daily work that made Gudeen suddenly think of a way to burn the magic array.

When burning the magic array, the element nodes are burned and connected to an object. This step is similar to the engraving method, except that the carrier of the burning is the invisible and intangible elemental magic power.

If you say that you make a burning template with elemental magic power, wouldn't you just need to 'print' lightly on the carrier to copy the structure of the magic array soon?

It sounds a little abstract, but the actual idea is a replica of movable type printing.

The magic array structure that originally required manual time-consuming and labor-intensive recording is handed over to mechanical recording, and when it is needed, it can be used directly by lightly 'printing' it.

The source of inspiration for this, Gu Deen still got from the purely mechanical face collector.

The structure of the magic array is not like magic, which requires a three-dimensional dislocation. If you insist on comparison, it may look more like a flat two-dimensional code.

It is also for this reason that the possibility of mechanically burning the magic array has been upgraded from impossible to possible.

If this method can be born, according to Gudern's plan, let alone the magic rifle, it is not impossible to create a magic computer later.

However, it is estimated that Gu Deen will find a group of "smart" magicians to research on that stuff instead of being tortured by himself.

When researching and manufacturing, once there is a goal and inspiration, the speed of research and development will become extremely fast.

From the research concept to the finished experimental device, Gudern completed it in less than three hours.

Looking at the three pieces of "Magic Formation Burning Original Embryo" in his hand that were not as big as a palm, Gu Deen was very excited at the moment.

Use the burning carrier to paste and burn other items in reverse. He doesn't know if anyone in the world is using this kind of operation.

But he knew that in the future, the era of science and technology industry in Qingyuan Town might turn into a magic industry.

The three burning original embryos are: fireball, magic gathering array, and element storage. These three are also the main magics for burning and manufacturing the second-generation magic rifle.

At the same time, on each original recording embryo, Gudeen deliberately lacked a structure of overlapping points and has not yet added it.

This lack point will be added to the hammer later. This design can also avoid the situation where the magical magic array absorbs and wastes the magic power of the elements.

After burning the original embryo, the next step is to test the burning work.

Gudeen put a silver gun receiver that had been made but had not burned the magic circle on the fixed table.

Then operate the magic hand to simulate the mechanical arm to carry out the burning work.

Burning the original embryo is not just a simple mechanical structure, but needs to provide it with elemental magic power, so that it can be burned for the item.

According to the order, the three magic arrays completed the burning work within five seconds. Looking at the flawless silver surface, Gudeen quickly installed it on the rifle, adding the hammer that was prepared in advance.

If there are no accidents, then he only needs to pull the trigger, and this mechanically recorded magic circle will be activated.

After taking a deep breath, Gudern slowly pulled the trigger.

Driven by the built-in machinery, the hammer at the tail quickly lifted to strike the missing structural point of the magic array.

Coupled with the magic power structure points in the hammer, the three magic circles completed their work almost instantly.

"boom--"

In less than a tenth of a second, a dull and slight implosion sound came from the gun body.

"It's done!"

Looking at the rifle that could be fired successfully in his hand, Gooden showed joy on his face.

He did not expect to complete the work so smoothly.

Looking at the three original recording embryos that were still in mid-air, Gudn thought for a while, and then called Els.

"Now go and pick a group of high-quality people, about ten people, and learn how to use the rifle. The operation method is the same as before."

As Gudeen said, he handed over the finished second-generation magic rifle to Els, and then continued.

"Each person shoots one hundred rounds, you two hundred rounds, get familiar with the use of this weapon as soon as possible, remember to find an open space where no one is around, and the guns are not allowed to be aimed at people."

"Yes!"

Els took the rifle and looked at the rifle in his hand with a little excitement in his eyes.

He had seen the power of the rifle before, but the young master single-handedly killed nearly a hundred orc scouts with this weapon.

He had also trained the use of the magic rifle before, but due to the limitation of magic power, it was very inconvenient to recharge it after firing three rounds.

Now the young master has allowed them to let go of the fight, compared to the fact that this restriction has been resolved, and it seems that they have already made plans to deploy the army, which makes Els very excited.

After accepting the next task, leave with bullets and weapons to shake people for training.

And Gooden immediately began to study the automatic recording equipment after interspersing and arranging the tasks.

It is far from enough to burn the original embryo. Gudern's plan is to make this work fully automated and mass-produced, so that it meets the conditions for mass production equipment.

As for automation equipment, for Gooden, who has participated in the research and development of steam engines and various equipment, it is easy to make.

With sufficient materials and the help of magic, a production line of 'magic gun receiver' adapted to steam-powered engines was soon completed.

Just like the assembly line, three recording blanks fixed by mechanical clamps are waiting quietly on a straight vertical mechanical arm.

At the same time, on the mechanical arm, there is an elemental magic power supply module the size of a glasses case, which is used to provide elemental power to burn the original embryo.

A set of magic weapon burning equipment, only half a meter wide and one meter long, this set is just a test platform specially made by Gudeen for the magic rifle.

Connected to the magic engine made before, under the action of mechanical force, three mechanical arms with original embryos are working up and down at the same time.

Gooden also made a silver gun receiver and put it on a fixed transmission belt to test the effect of automation.

The mechanical arm that falls once every two seconds needs six seconds to burn the magic circle. Although it is twice as slow as manually controlling the original embryo burning, this thing is automatic!
If all the conditions are sufficient, this thing can run 24 hours a day without stopping.

And can he make it by hand for 24 hours a day?

Even if it is possible, what about one day?What about two days?

On the long-term axis, manpower is bound to be inferior to machinery, which is the biggest advantage of industrial mechanization.

Looking at the receiver of the magic gun in his hand, Gudeen thought for a while and cut off the magic power of the magic engine.

Then he took the design drawings of the second-generation firearms and the receiver to the research institute.

In Qingyuan Town, if the area that has changed the most is the area occupied by the Research Institute.

As Gudern's key development project, the resources here are equivalent to unlimited investment.

There is even a 20-person engineering team directly serving the construction of the required venues.

It is precisely because of this kind of resource investment that the surrounding area of ​​the research institute is almost demolished every two days, changed every three days, and changed every five days for further training and upgrading.

Not only is there a fence around it, but there are also three more experimental buildings inside, like two large one-story test buildings.

And one of the four-story dormitories is also the first building in Qingyuan Town to be equipped with heating and running water pipes.

Coming to the special meeting room, Buck, who got the news, brought relevant personnel here one after another, waiting for Gudn's new order.

"The research tasks in your hands now need to be slightly changed, and the goals that need to be mass-produced now are these two."

Gooden took out the blueprint and the prototype of the gun receiver as he spoke.

"The design blueprint is here, you will study it later, the research idea is still the same, just change it to these two items."

"Buck, after the meeting is over, you call the heads of the other projects and suspend all the tasks in hand, leaving only the infrastructure research department so that they can keep up with the construction work of the engineering team."

"All the others have been transferred to this development task. I need to see the finished product before the end of this month."

Buck was also a little surprised when he saw that Master Gooden dispatched nearly the entire research institute to participate in these tasks.

The last time I did this kind of project was when I was researching steam engines.

But at that time, there were only about [-] people, but now it is necessary to mobilize more than a hundred people. This scale and research goals made Buck curious and excited.

As the number one person in charge of the research institute, he admired all kinds of wonderful ideas put forward by the young master.

Now that there is a new big project, he immediately stood up and agreed in a solemn voice.

"Yes, I will arrange related work."

After simply arranging the tasks, Gudeen stayed and helped everyone solve some problems before returning to the castle.

Now that I have been able to achieve mechanized recording, can my goal be set further?
For example, magic cannons, magic cars, etc...?
　Thanks to the starting point readers: Rotsen, 500 starting point coins for the reward!
　　
　
(End of this chapter)