Halfway through assembling the two plans, Du Changshun discovered that there weren't enough parts.

He counted them twice, pointing to the relays on the table.

"Two more are needed."

Li Mingyuan took the material requisition form.

"There are new ones in the equipment room. Go get them tomorrow morning."

Lin Xiuhe opened the scrap box and found four old relays inside.

The paint on the outer shell is peeling off, and the joints are blackened; when placed side by side, they are almost indistinguishable.

Use this.

Li Mingyuan picked one up and pressed the bit.

"The conditions are different, so the test results will be inaccurate."

"Then take it apart, clean it, and rearrange it after you've shuffled it."

He Qiuyan found some fine sandpaper and sanded off the black spots on the contacts one by one. Du Changshun put the four relays into the wooden box, closed the lid, shook it a few times, and then let Zhao Guodong pick one up casually.

Each of the two plans received two old parts.

No one benefits.

The five people worked until dark before they finally placed the two sets of equipment side by side on the test bench.

Li Mingyuan's circuitry was dense, with relays stacked one on top of another.

Lin Xiuhe's side was much simpler; once the cover was opened, the main line and control line were clearly separated.

Zhao Guodong brought back five steamed buns from the canteen.

"These are all that's left."

Du Changshun reached out and took one.

"Where's the pickled vegetable?"

"The window says they're sold out."

He Qiuyan took a small packet of dried radishes out of her schoolbag and placed it in a blank space on the drawing.

"Use it sparingly."

The five of them finished their dinner around the lab table.

Li Mingyuan wiped the crumbs off his hands and pushed the record sheet to He Qiuyan.

"Test the performance first."

Zhao Guodong switched on the power.

Li Mingyuan's plan is to first connect the power source.

Pressing the button starts the motor quickly, the pointer moves past the mark and then stabilizes. Forward, stop, and reverse rotations switch crisply and continuously.

He Qiuyan reported the data, and Du Changshun timed it.

After five rounds, Li Mingyuan's system responded faster and had less error.

Zhao Guodong stared at the record sheet.

"The difference is quite obvious."

Li Mingyuan placed the pencil next to the form.

"This system is more suitable for evaluating engineering projects based on control effectiveness."

Lin Xiuhe connected her device to a power source.

The second set started a little slower, and the pointer swung a few more times.

For five consecutive rounds, the data has consistently lagged behind.

Li Mingyuan took the two record sheets and placed them side by side on the table.

"The speed is slower, and the error is one grid more."

"continue."

"What else is there to test?"

"Continuous operation and fault recovery."

Li Mingyuan pointed to the assessment instructions on the wall.

"The requirements did not include fault testing."

"The equipment always breaks down after it enters the workshop."

Having learned his lesson at the North City Factory, Zhao Guodong immediately chimed in.

"This should be tested."

Li Mingyuan put the instructions back on the desktop.

"Okay. How do we test it?"

Lin Xiuhe took out two slips of paper.

A sign reads "Poor contact at the connection point."

A sign reads "Control line loose".

She folded the paper and held it in her palm.

"Draw one question from each set. He Qiuyan and Du Changshun will do it; the others will not be reminded."

Zhao Guodong drew a faulty contact point.

As instructed on the note, he made the same treatment on the old relays of both sets of devices.

Then, the five people made both motors run simultaneously.

More than half an hour later, a rapid vibration came from Li Mingyuan's side.

The motor was turning intermittently.

Lin Xiuhe's routine also stopped after a few minutes.

Zhao Guodong turned off the power switch and placed the pocket watch on the table.

"start."

He Qiuyan first checked Li Mingyuan's plan.

The circuit was divided into three layers, with many connection points and wires crammed together. She measured section by section along the diagram, and when the probes reached the innermost part, her cuffs touched the wires next to her several times.

Following Lin Xiuhe's method, Du Changshun first checked the main line after lifting the cover, and then checked the two relays.

In less than five minutes, he pointed to one of the contacts.

"The reading jumps here."

He Qiuyan's side is still investigating further.

Zhao Guodong announces the time.

"Six minutes."

Du Changshun cleaned the joints and tightened them again.

In the eighth minute, Lin Xiuhe's device resumed operation.

Li Mingyuan stood next to his own set, holding the blueprints to show He Qiuyan the positions, but did not say anything to remind her.

Twelve minutes later, He Qiuyan finally found the fault.

It took another nine minutes to remove the sutures, clean them, and reconnect them.

In the twenty-first minute, the motor started running again.

Only the hum of two machines remained in the laboratory.

Li Mingyuan picked up the record sheet and paused for a moment in the repair time column.

"The control line was found to be loose upon retesting."

This time, He Qiuyan was in charge of Lin Xiuhe's plan, while Du Changshun investigated Li Mingyuan's plan.

After Zhao Guodong finished processing the circuit according to the note, he restarted the timer.

Lin Xiuhe had fewer lines, so He Qiuyan quickly traced the loose connection all the way to the terminal.

Seven minutes later, recovered.

Du Changshun disassembled the two layers of wiring channels, but misplaced the watch once. By the time the motor restarted, the pocket watch had already ticked for nineteen minutes.

The results from both rounds were laid out on the table.

In performance testing, Li Mingyuan had the advantage.

The fault was recovered, and Lin Xiuhe's recovery time was nearly twice as fast.

Du Changshun put the screwdriver into the toolbox.

"I can assemble Li Mingyuan's system by following the diagram. The real problem is in the workshop; once the cover is opened, it takes forever to find the parts."

He Qiuyan placed the two old relays together.

"New parts always look good. But with more old parts, there are more joints, and more potential problems."

Li Mingyuan spread out his circuit diagram and traced the three layers of control lines with a pencil.

"My response time is four seconds faster, and the error is one notch less."

"Your recovery is thirteen minutes slower."

Zhao Guodong turned the two record sheets in front of him.

"If the North City factory really stopped for thirteen minutes, Old Shao would have yelled at us from the workshop all the way to the gate."

Li Mingyuan looked up.

"His swearing has nothing to do with the plan."

"It doesn't matter how long you scold them."

Du Changshun almost dropped the dried radish he was eating.

He Qiuyan turned her face away, her shoulders trembling slightly.

Li Mingyuan couldn't resist tapping the table with his pencil.

"Let's get down to business first."

Lin Xiuhe placed the cost sheet between two sheets of paper.

Li Mingyuan's set had three more relays, and also more wires and contacts.

Based on current prices, the total cost is nearly 50% higher.

"Your solution will perform very well in the lab."

Lin Xiuhe pointed to the performance data.

"It would be useful to put it in a factory with good conditions."

She pushed the fault log over.

"Small factories can't afford to use so many new parts, and if they break down, there might not be anyone who can trace the three layers of circuitry. A day of machine downtime results in a greater loss than that little bit of precision."

Li Mingyuan recalculated the cost and added the repair time together.

He wrote two words next to his proposal.

Enhance.

Then, next to Lin Xiuhe's picture, I wrote:

Base.

Zhao Guodong came closer.

"What does this mean?"

"This is her basic plan."

Li Mingyuan circled the high-precision control section in his circuit with a pencil.

"Add this section when higher precision is required."

Lin Xiuhe took the pencil and filled in the gap between the two sets of drawings.

"Basic controls are used normally."

"Special equipment plus enhancement modules."

He Qiuyan immediately pulled over the new record sheet and redrawn the table.

Du Changshun removed an extra relay and put it back in the wooden box.

Zhao Guodong watched as the two images slowly merged into one, and grinned.

"That way, no one's efforts were in vain."

There were two knocks on the door.

The student on duty poked his head in and handed over a notice.

"Professor Chen asked me to deliver it. Tomorrow morning at eight o'clock, in Laboratory Hall 1 of the Automation Building, for the engineering design assessment."

Du Changshun looked at the table full of wires.

"Tomorrow morning?"

Li Mingyuan rolled up the old drawing and rolled up his sleeves.

"There's still time."

Lin Xiuhe placed the new plan in the center of the test bench.

"Finish it tonight."

He Qiuyan picked up the wire strippers.

Zhao Guodong closed the toolbox again.

Du Changshun brought over an empty baseboard.

The five people sat around the table, and none of them mentioned going back to the dormitory.

Tap the screen to use advanced tools Tip: You can use left and right keyboard keys to browse between chapters.

You'll Also Like