Ming Dynasty: I am truly not the Emperor of Longevity

Chapter 328 The technology tree isn't so easy to climb!

Wenhua Hall, rear hall.

"Your Highness, the Ministry of Works' Ordnance Bureau has successfully replicated one hundred flintlock muskets."

Song Bai, the Assistant Director of the Ministry of Works' Bureau of Imperial Sacrifices and Censors, reported to Lu Chen.

"As Your Highness instructed, the gun barrel was not cast in bronze, but was made of double-layered wrought iron, just like the guns of the Franks. The inner wall of the gun barrel was polished with a steel core."

Apart from that, all other components were completely copied from the flintlock muskets seized from the religious bandits.

After officially becoming the Prince Regent, Lu Chen quickly issued an order to the Ministry of Works to produce replicas of flintlock muskets.

Of course, there's no need to use expensive bronze to cast gun barrels like the time traveler on Blackwood Cliff.

Historically, there were indeed firearms with bronze barrels, and their performance was not bad, but they were too expensive to manufacture and very few survived. They were often just toys in the hands of high-ranking officials and nobles.

Lu Chen knew very well that if it was just small-scale production, using bronze for the gun barrel was certainly not a problem. It was easier to produce, the production period was shorter, and it was less likely to explode.

However, bronze was too expensive, and the Ming Dynasty's copper production was still very low, with most of it having to be imported.

If mass production and large-scale deployment to the armed forces are desired, manufacturing costs must be taken into account.

The technique of rolling double-layered wrought iron into gun barrels was used by Europeans from the 15th century, the era of matchlock guns, until the early 19th century, when it was replaced by more advanced integral forged steel and cast steel drilled barrels before the Opium War.

The prerequisites for drilling integral forged steel and cast steel were not yet met by the production technology of the Ming Dynasty.

As a last resort, they adopted a double-layer wrought iron sheet rolling process.

Lu Chen believed that this gun barrel manufacturing technology, which Europeans had used for hundreds of years, must be the optimal solution under the current level of productivity, after comprehensively considering performance and cost.

Since that's the case, there's no need to take detours and make mistakes; just adopt it directly.

Three months later, the Ministry of Works finally produced a batch of flintlock muskets.

"What is the cost of each flintlock musket?"

Lu Chen asked,

"How long will the construction period be, and how many times can the hammer spring be successfully fired without deforming?"

"Your Highness, when the Ordnance Bureau first started making the copy, the production process was a bit slow and a lot of materials were used up."

Song Bai was clearly prepared.

"After successfully making several flintlock muskets, the foremen of the Ordnance Bureau finalized the manufacturing process. The production of the remaining ninety-odd muskets took about a month."

Each musket takes a month to produce.

His Highness has ordered the Ministry of Works to produce only one hundred replicas this time. The Ordnance Bureau has enough craftsmen to work on them simultaneously. If more are needed, either more craftsmen will be recruited from various places, or the production period will be extended.

The cost of materials and labor for each flintlock musket was approximately six taels of silver.

As for the hammer spring, the Ordnance Bureau tried using the same bronze spring as the sample, which was easy to make, but it could only fire thirty or forty times before it had to be replaced.

Springs made from Suzhou steel can last longer, but their quality varies greatly, and the springs made by different craftsmen differ significantly.

Several experienced master craftsmen are occasionally able to create reeds that can be fired hundreds of times.

However, most of the reeds crafted by artisans were not much better than bronze reeds, and some were even worse.

After I discovered this, I instructed the skilled craftsmen to put aside their other tasks and focus on making the reeds. Now, all one hundred flintlock muskets are equipped with reeds that can fire at least a hundred times.

The Ordnance Bureau still has about one hundred pieces in stock.

"How many craftsmen did the Ministry of Industry's Ordnance Bureau have that could simultaneously produce gun barrels?"

Lu Chen nodded slightly and continued to ask.

The most time-consuming part of manufacturing matchlock and flintlock guns was the barrel. According to records, it took about a month to manufacture a qualified barrel for a European matchlock gun, a Japanese arquebus, or a Ming Dynasty musket.

Meanwhile, the other parts had already been completed and were just waiting to be assembled after the barrel was finished.

The fact that the Ministry of Industry could achieve this level of efficiency in just three months shows that its manufacturing capabilities are quite good.

As for the price of six taels, Lu Chen also felt it was quite reasonable.

According to Xu Guangqi's records from the Wanli era, a high-quality replica of a Portuguese matchlock musket that was not prone to barrel explosion cost around four taels of silver.

Of course, at the same time, the Ministry of Works was producing shoddy muskets, using single-layer wrought iron sheets to make the barrels, and the cost had been reduced to less than two taels of silver.

These muskets were very prone to exploding, making them a nightmare for the Ming army.

Compared to matchlock guns, flintlock guns have more precision mechanical components such as hammers and springs, so their cost is definitely higher.

Moreover, these one hundred flintlock muskets were ordered to be replicated by the Prince Regent himself, and the officials of the Ministry of Works knew that he would personally inspect them, so they would never dare to cut corners.

It's understandable that the cost was higher than that of the matchlock guns from Xu Guangqi's time.

As expected, although mass production was not possible, the skilled craftsmen of the Ming Dynasty were capable of handcrafting steel reeds that could be fired hundreds of times.

However, the output was indeed rather meager.

Even the prestigious Ministry of Works Ordnance Bureau could only produce one or two hundred pieces per month.

A reed that can fire hundreds of times in a row is certainly enough for a battle, but it still needs to be replaced after the battle.

Ultimately, it's still a consumable item and can't withstand large-scale battlefield consumption.

Moreover, these reeds are hand-made by skilled craftsmen based on their experience; without a standardized production process, mass production is simply impossible.

Before the standardization of spring steel production in mass production was possible, flintlock muskets could only be produced in small quantities and equipped by small elite units.

No wonder, flintlock muskets appeared in Europe as early as the late 16th century, but were not used in the military on a small scale until the mid-17th century.

The flintlock musket truly replaced the matchlock musket in European armies only at the end of the 17th and beginning of the 18th centuries.

It took Europeans a full hundred years to be able to mass-produce qualified springs for flintlock musket hammers.

It seems that climbing this technology tree is not so easy.

Knowing the manufacturing principle does not guarantee that you can produce a finished product.

They had no choice but to settle for second best and mass-produce reliable matchlock guns to equip the Ming army.

"Your Highness, there are 854 registered blacksmiths in the Ordnance Bureau."

Song Bai quickly replied,

"But these craftsmen also had the task of making military weapons such as waist knives, spearheads, and armor plates, and could not all be transferred to make gun barrels."

The maximum production capacity is three hundred gun barrels per month.

"Three hundred per month is too few."

Lu Chen stood up.

"By my decree, blacksmiths from all over the country are to be recruited to set up a workshop in the Ordnance Bureau specifically for manufacturing firearms."

There's no need to manufacture flintlock muskets for now. These muskets use the same ignition mechanism as the Portuguese, which is a matchlock.

However, the barrel must be made of double-layered wrought iron. Do not make shoddy products to save costs. Quality must be checked at every stage. Each musket must be inspected by a dedicated person, and their name must be engraved on it for accountability.

Gather those skilled craftsmen who can forge qualified steel reeds and have them specifically study how to mass-produce reeds.

"Song Qing, I'm giving you one year to increase the production capacity of this musket workshop to over a thousand muskets per month."

Tap the screen to use advanced tools Tip: You can use left and right keyboard keys to browse between chapters.

You'll Also Like