Lu Wei stood in front of the worktable and placed the metal lump, which was tightly wrapped in black charcoal and salt, on the table.

He picked up a bucket of industrial-grade rust remover that he had just bought yesterday, unscrewed the cap, and poured the pale yellow liquid directly onto it.

Time passed second by second, but the expected chemical reaction of dissolving and bubbling dirt did not occur.

The thick layer of mixture acted like a bulletproof vest, and the rust remover flowed down the rough surface onto the table, doing nothing to remove it.

This outer shell is incredibly hard, so conventional acidic solutions obviously won't work.

"Holy crap, is it that hard?" Lu Wei raised an eyebrow, his expression not looking too good.

He grabbed a small hammer from his toolbox, gestured to the point of impact, and tried to break the shell by physically striking it.

But before the hammer could fall, he abruptly stopped what he was doing.

This thing is encased inside a Rolex Submariner green, which is known as the pinnacle of precision mechanics.

The movement is filled with delicate ruby ​​bearings and hairspring components as thin as a hair.

This hammer blow might shatter the outer casing and cause the 120,000 yuan movement inside to crumble into a pile of worthless debris.

Lu Wei put down the hammer and focused his attention on the metal lump on the table.

The blue panel in the lower right corner of the retina began to refresh rapidly.

[Host has encountered a cleanup bottleneck. Deep matter analysis mode initiated.]

[Analysis of the composition of the deposits: a high-temperature sintered body consisting of 60% ferrous carbonate and 40% deep-sea sulfide salts.]

[Physical properties: This sintered body is immune to common weak acids and alkaline solvents, and its molecular structure is stable.]

Looking at the detailed chemical composition report, Lu Wei stroked the stubble on his chin.

Now that we know the specific ingredients, the rest is easy.

He took out his phone, opened a webpage, and searched for relevant formulas for neutralization reactions in industrial chemistry.

Entering the keywords "ferrous carbonate" and "deep-sea sulfide salts" brings up a variety of obscure and difficult-to-understand chemical equations.

After more than ten minutes of comparison and calculation, he identified a highly targeted pickling formula.

A high concentration of industrial oxalic acid is required as the main agent, combined with a specific ratio of fluorotitanic acid reagent, in order to tear a hole in this hard sintered body.

He had the formula, but he didn't have either of the two uncommon chemical reagents on hand.

He locked the metal lump in the drawer, pulled down the roller shutter, and went out again.

This kind of high-risk reagent is not available in ordinary hardware stores, so he could only try his luck at the old chemical raw material factory in the suburbs.

If you're lucky, you might be able to buy one; if you're unlucky, you might end up with a hat on your head.

After changing buses twice on dilapidated buses without air conditioning, he arrived at the factory's residential building, which reeked of chemicals.

There happened to be an old shop on the street that specialized in selling all kinds of industrial reagents.

Pushing open the yellowed glass door, I saw an old man wearing reading glasses reading a newspaper behind the counter.

"Sir, do you have any high-concentration oxalic acid and fluorotitanic acid reagents?"

Lu Wei stepped forward and stated directly what he needed.

The old man put down his newspaper, glanced at him through his glasses, and looked at him with a hint of wariness in his eyes.

"These are all regulated corrosive chemicals. Which factory are you a purchasing agent for? Do you have a letter of introduction with an official seal?"

"I'm a self-employed metal machinery refurbisher, and I urgently need these two chemicals to remove heavy rust."

Lu Wei placed his ID card directly on the glass counter.

"I understand the rules, I can register with my real name and leave my ID number."

The old man took the ID card, checked the photo, turned around, took out a thick registration book from the drawer, and pushed it over.

Please clearly state your name, phone number, and purpose of the transaction.

The old man pointed to a blank space in the register.

"These two medicines are highly corrosive; if they get on your skin, they can burn away the skin and flesh. Be careful when using them yourself."

Lu Wei picked up a pen and quickly filled in his personal information.

The old man took the key, walked to the explosion-proof cabinet at the back, and took out two dark glass bottles with skull and crossbones warning signs.

"It's two hundred and twenty yuan in total."

After a long and arduous ride on a swaying bus, I finally made it back to the auto parts market in the southern suburbs. By then, it was already dark outside.

Lu Wei pulled open the roller shutter door and turned on the incandescent light above his head.

He walked to the worktable and put on thick, industrial-grade acid and alkali resistant rubber gloves.

He then found a gas mask with a double filter cartridge and put it tightly on his face.

He dared not be careless when dealing with this strong acid reagent.

Inhaling the toxic fumes will ruin your health for life.

He pushed the 20-liter ultrasonic cleaner near the vent, filled the stainless steel inner tank with more than half a tank of water, and turned on the heating.

To prevent the strong acid from corroding the inner tank of the cleaning machine, he found a special acid-resistant plastic beaker and suspended it in hot water to serve as a reaction vessel.

Lu Wei unscrewed the cap of the oxalic acid bottle and, according to the ratio he found, slowly poured the clear acid into the beaker.

He then used a dropper to draw a small amount of fluorotitanic acid reagent and carefully added it to the oxalic acid solution.

The moment the two reagents were mixed, a puff of white smoke rose from the surface of the liquid.

Lu Wei held his breath, picked up the metal lump covered in coke and alkali with long-handled stainless steel tweezers, and threw it directly into the prepared mixed industrial acid solution.

The chemical reaction erupted at that moment.

The mixed acid solution, specifically designed for such complex components, exhibited a powerful stripping ability.

As soon as the metal lump came into contact with the liquid, countless white bubbles immediately formed in the beaker.

As the pungent sulfide gas rose, the solid, high-temperature sintered body rapidly disintegrated under the corrosive effect of the acid.

The originally clear acid solution quickly turned into a turbid, dark brown color.

Large chunks of carbonized residue floated on the water's surface.

Lu Wei reached out and pressed the panel, thus activating the high-frequency vibration function of the ultrasonic cleaner.

Strong physical waves penetrate the hot water and act on the beaker, creating the illusion of boiling.

The salt and alkali blocks hidden deep in the crevices were subjected to high-frequency vibrations, which accelerated the process of peeling and detaching.

Twenty minutes later, the chemical reaction in the beaker gradually subsided.

Lu Wei turned off the ultrasonic device and used long-handled tweezers to pick up the object from the bottom of the water.

He rinsed off the remaining acid with clean water and placed it on a lint-free cloth on the worktable.

That troublesome hard shell has been completely dissolved.

The original outline of the green Submariner diving watch was clearly displayed before his eyes.

However, its condition is still appalling.

The 904L stainless steel case, after being subjected to the dual effects of seawater and high temperatures, has developed a dull, oxidized gray color.

The scratch-resistant sapphire crystal glass above the dial has shattered into a mesh-like pattern.

Through the cracks in the broken glass, you can see a dark green dial filled with watermarks and silt.

Lu Wei took off his gas mask and took deep breaths of the fresh air circulating in the garage.

He looked down at the data that was refreshing in the lower right corner of his field of vision.

[Current item dirt level: 30%]

The outer armor has been forcibly removed; the next step is to deal with the fatal damage inside the movement.

Tap the screen to use advanced tools Tip: You can use left and right keyboard keys to browse between chapters.

You'll Also Like